Youngneer 12v Relay Board Relay Module 1 Channel Opto-Isolated High or Low Level Trigger


Price: $11.99 - $10.99
(as of Nov 27,2022 17:15:10 UTC – Details)



Specification:
Material: Circuit board
Control signal: TTL
Rated load: AC125~250V/10A, DC28~30V/10A
Max. switch voltage: 250VAC, 30V
Operating Voltage:12V
Trigger Current: 5mA
Max. Current: 190mA
Size: 50mm * 26mm * 18.5mm (1.9 inch *1.02 inch * 0.72 inch )

Module interface:
1. DC+: positive power supply (VCC)
2. DC-: negative power supply (GND)
3. IN: can be high or low level control relay

Relay outputs:
1. NO: normally open relay interface
2. COM: Common Interface Relays
3. NC: normally closed relay interface

High and low level trigger options:
It is low level trigger when jumper connect to LOW pin
It is high level trigger when jumper connect to HIGH pin

LED Indicator Light:
Power Indicator: Green
Indicator of Relay Status: Red

100% Satisfaction Guarantee:
12-Month Warranty; No satisfied, Free reason for return; Quality problem, please contact us, we will
resend your FREE Replacements or make you FULL Refund.

【12V 1 Channel Relay Module】- This Relay Board provides a single relay that can be controlled by any12V digital output from your microcontroller.
【Main Specification】- Peak Load of NO Connector: AC125~250V/10A, DC28~30V/10A; Trigger Current: 5mA;The Module Operating Voltage:12V; 4pcs * 3.1 mm Fixed Bolt Hole.
【Adopted SMD Optocoupler Isolation& jumper Set】- The isolation circuit prevent damages to I / O port by relay switch current.The module has a jumper so you can set rather the unit state changes with high or low signal. Has screw terminals for relay (NC,C,NO) and for input; Coil +, coil – and trigger.
【Wide Application】-These 12v relay board works well with ARM /PIC /AVR /MCU/Raspberry/CNC machine/ PS4 etc.
【Humanization Design On Interfaces】- All interfaces can be directly wired out through the terminals.Fault-tolerant design;fault-tolerant design,even if the control line is broken, the relay will not operate.

Leave a Comment

Your email address will not be published. Required fields are marked *